Lee 6mm Remington Factory Crimp Die in Red Box

Updated September 23, 2026

One Lee Precision Factory Crimp Die for 6mm Remington, part number 90832, in the original red box with the factory instruction sheet and the barcode label intact on the end. A factory crimp die is the last die in the sequence. After the bullet is seated, this die closes four hardened collet fingers on the case mouth and presses a clean crimp into the bullet from the outside, which gives the same result on every round even when case length varies. Handloaders reach for it when they want consistent neck tension without trimming every case to a single length. The 6mm Remington is a fast, flat shooting round that does well on deer and coyotes, and a good crimp keeps bullets from setting back in the magazine during recoil. This die fits any press with standard seven eighths by fourteen threads. Condition is excellent. The die is bright with clean threads, the collet works and the box and paperwork show only light shelf wear. Estimated Value: $15 to $25 based on comparable recent sales. Sold as-is. Photos are the most accurate description of this lot. Written descriptions are a guide only and may contain errors. Please review all photos before bidding.

Register & bid on this lot at Bidspirit →

More lots in this auction

• Lee 6mm Remington Factory Crimp Die 90832
• Lee Universal Case Expanding Die in Box
• Lee 243 Winchester Factory Crimp Die 90819
• Lee Hand Priming Tool Shell Holder Set of 11
• Lyman 38 Special 357 Magnum Carbide Sizer Die
• RCBS 6mm Remington 2 Die Full Length Set
• RCBS 380 Auto Taper Crimp Seater Die 20462
• RCBS 243 Winchester 2 Die Set 11401 Green Box

See all lots in Ferguson Family Ammo, Reloading, and Outdoor Supplies →