1966

Updated October 21, 2026

1966 U15 I believe and once again we have a frame that is pretty much gone. However there are a lot of parts and it's like the one before. The front half of the frame could be used if you had a good back half. Not much left of the body either. All the A and B pillars are bad as is all the floor pan. There is a complete 6 cylinder and it turns free by hand, three speed and T case intact with both drive shafts. Rear and front ends are complete. Some of the steering is off but looks to all be in the bed in the back. The drivers door with what looks to be a good window frame and vent glass are also in the rear. Door inner workings are also in the rear. It does have a factory bench seat with bulk head and a nice dash. I will repeat again, if you have ever done a 66' and tried to put it back original these old junk Broncos are a must to have around. You simply can't get a lot of the parts after market, such as the bumpers, bench seat, etc. and a lot of the bolts and small parts that are all over these, so there is value. Best buy this one for parts or just to get the serial number off the frame, I don't consider it a candidate to be built at all but it could be stripped down completely and a lot of good parts used or to be sold.

Register & bid on this lot at Bidspirit →

More lots in this auction

• 1975
• 1977
• 1966 U13
• 1966
• 1976
• 1967
• 1969 U15O6LF59301
• Bronco

See all lots in Early Ford Bronco Vehicles and Parts Auction →