BougeRV Arch 200W Flexible Solar Panel 12V

Updated August 7, 2026

Lot number	2343
Estimate	210.00 USD
Auction	8/10 Back to School, Back to Bidding
Date	August 10, 2026 at 5:00 PM CDT
Auction house	Budget Barn
Location	Gallatin, Tennessee

Title: BougeRV Arch 200W Flexible Solar Panel 12V Retail_Price: $210 Condition: Open Box Double Fiberglass Protect increases the impact resistance. No worry about the crack. Double glass fiber is placed on the upper and lower layers of the mono solar cell for protection, which can avoid damage to the mono solar cell to the greatest extent Max To 270 Flexible. Matches more curved surfaces, allowing you to install where rigid solar panels cannot. Make full use of the limited space on the roof or even the curved part of the front of the car ETFE Covering Material. Using ETFE instead of PET, will not delaminate after long-term use, so it has a longer service life. It has anti-scratch/self-cleaning/sand-proof capabilities and can resist impact and abrasion, preventing collisions and possible wear, scratches, etc. This happens frequently during transportation and maintenance activities Lightweight and Easy to Carry. Ultra Lightweight-Only 7 lbs and Thin-Only 2mm. The BougeRV factory uses special lamination technology to make fiberglass flexible solar panels light and thin, leading in the market, and easy to move Multiple Protective Material Insulation. Effectively reduce module temperature by -0.39%/ , and improve output power By 6W 10BB Cell Design. More Busbar, More Power. BougeRV 200W glass fiber flexible solar panel uses the high-level 10BB cell design with a 23% highest conversion rate. It makes the solar panel have a longer service life. Increase the cell receiving surface, a thinner ribbon reduces the covered area by 22%. Also, it can charge a 12V battery or a 24/48V battery by wiring several solar panels in series Easy installation: There are pre-punched holes for easy installation. You can also apply glass glue for quick installation. And you can also attach the sticky tape (sold separately) to the back for easier installation High Wind & Snow Load Design: This panel supports wind loads up to 2400 Pa and snow loads up to 5400 Pa, and is suitable for low-light environments. The IP68 waterproof junction box protects against dust and low-pressure water jets. Diodes are pre-installed, with 3ft cables pre-attached. Pre-drilled holes on the back allow for easy installation.

More lots in this auction

See all lots in 8/10 Back to School, Back to Bidding →